Which is better, Gear type Slap Sieve or Belt type Slap Sieve?

Wednesday March-15 2023  09:50:56

The Gear-type Slap Sieve is installed on a horizontal foundation with anchor bolts, and the circuit and grounding are installed according to electrical regulations. The Gear-type Slap Sieve motor passes through the synchronous belt, drives the gear to change the speed, and makes the main shaft rotate. Material sieving in test sieves and sample sieves.

The Belt-type Slap Sieve is a new type of slap sieve upgraded from the Gear-type Slap Sieve. The eccentric wheel set adopts an integral method, which is accurate and convenient to install again. The rotating part adopts standard bearings, which are not easy to wear and easy to replace , Low cost, greatly reducing the difficulty and cost of maintenance.

Compared with the two, it is better to choose the Belt-type Slap Sieve, the main reasons are as follows:

1. Belt-type Slap Sieve is easier to operate

The Belt-type Slap Sieve adopts the overall method, which is accurate and convenient to install again. The rotating part adopts standard bearings, which are not easy to wear, simple to replace, and easy to operate.

The Gear-type Slap Sieve needs to be filled with oil before the first time. When the slap sieve is started, the ejector rod needs to be jacked up and fixed with screws. If there is a failure during operation, the thread head needs to be readjusted after stopping It is easy to cause the fuse of the flapping screen to burn out.

2. Belt-type Slap Sieve has a longer service life

Belt-type Slap Sieve has no direct contact between the gears, so there is no wear, more durable and less costly. Moreover, the adaptability between the synchronous belt and the gear is better, and only the belt needs to be replaced during maintenance.

However, the Gear-type Slap Sieve needs to be checked to see if the insurance is normal during use, otherwise it needs to be replaced. The Gear-type Slap Sieve has a limited service life. When the gear is damaged, it needs to be returned to the factory for repair, and the maintenance cost is high.